Winding/Installing The Bobbin; Winding The Bobbin - Brother 882-W83 Operation Manual

WINDING/INSTALLING THE BOBBIN

WINDING/INSTALLING THE
BOBBIN

Winding the Bobbin

IMPORTANT
• Use the plastic bobbins that came with this
machine or bobbins of the same type: 11.5 mm
(approx. 7/16 inch) plastic Class 15 (A style)
bobbins, which are available from your
Brother dealer.
 Using the Supplemental Spool Pin
With this machine, you can wind the bobbin during
embroidering. While using the main spool pin for
embroidery, you can conveniently wind the bobbin using
the supplemental spool pin.
1 Supplemental spool pin
a
Turn the main power to ON and open the top cover.
b
Align the groove in the bobbin with the spring on the
bobbin winder shaft, and set the bobbin on the shaft.
a
1 Groove in the bobbin
2 Spring on the bobbin winder shaft
c
Place the spool of thread for the bobbin and the spool
cap onto the supplemental spool pin.
Slide the spool onto the supplemental spool pin so that
the thread unwinds to the front from the bottom.
Otherwise the thread may become tangled around the
supplemental spool pin.
1 The thread unwinds to the front from the bottom.
22
a
a
d
Slide the spool cap onto the spool pin as far as possible
to the right, with the rounded side on the left.
IMPORTANT
• If the spool or the spool cap is not installed
correctly, the thread may become tangled
around the spool pin, and the machine may be
damaged.
• Three spool cap sizes are available, allowing
you to choose a spool cap that best fits the size
of spool being used. If the spool cap is too
small for the spool being used, the thread may
catch on the slit in the spool or the machine
may be damaged. When using mini king thread
spool, use the thread spool insert.
For details on thread spool insert (mini king
thread spool), refer to "Note" on page 22.
Note
• When using the spool as shown below, use the
thread spool insert (mini king thread spool). Make
sure that the thread spool insert is firmly inserted.
After installing it, pull out some thread, and check
that the thread unwinds without getting caught.
1 Thread spool insert
(mini king thread
spool)
2 Hole diameter 8.0
mm to 10.5 mm
(approx. 5/16 inch
to 13/32 inch)
3 Spool (cross-
wound thread)