Par Am Et Er S; Parameter List; Parameter Group - Danfoss VLT FC 100 Manual

VLT® FC 100 LonWorks

8 Par am et er s

8.1 Par am et er list
8.1.1 Param et er list
Par. No. Param et er nam e:
8-01 Control Site
8-02 Control Word Source
8-03 Control Word Timeout Time
8-04 Control Word Timeout Function
8-05 End-of-timeout Function
8-06 Reset Control Word Timeout
8-07 Diagnosis Trigger
8-10 Control Word Profile
8-50 Coasting Select
8-52 DC Brake Select
8-53 Start Select
8-54 Reversing Select
8-55 Set-up Select
8-56 Preset Reference Select
11-00 Neuron ID
11-10 Drive Profile
11-15 Lon Warning Word
11-18 LonWorks Revision
11-21 Store Data Values
8.2 Par am et er Gr oup 8-* *
8-01 Cont r ol Sit e
Opt ion:
[0] * Digital and ctrl.word
[1] Digital only
[2] Controlword only
8-02 Cont r ol Sour ce
Opt ion:
[2] FC USB
[1] Drive Port
[0] None
[1] FC Port
Def ault value:
Dig. and control word [0]
FC Port [1]
600 s
Off [0]
Hold set-up [0]
Do not reset [0]
Disable [0]
FC profile [0]
Logic OR [3]
Logic OR [3]
Logic OR [3]
Logic OR [3]
Logic OR [3]
Logic OR [3]
00 00 00 00 00 00
VSD 6010 [0]
0
[0, 10]
Off [0]
Funct ion:
The setting in this parameter overrides the settings in par.8-50
Reference Select
.
Control by using both digital input and control word.
Control by using digital inputs only.
Control by using control word only.
Funct ion:
Select the source of the control word: one of two serial interfaces or four installed options. During
initial power-up, the frequency converter automatically sets this parameter to
detects a valid fieldbus option installed in slot A. If the option is removed, the frequency converter
detects a change in the configuration, sets par. 8-02
Port
, and the frequency converter then trips. If an option is installed after initial power-up, the
setting of par. 8-02 Control Source
Alarm 67 Option Changed .
®
MG.11.E2.02 - VLT is a registered Danfoss trademark
Conversion
Range:
t ype:
[0 - 2]
[0 - 4]
0.1 - 18000
[0 - 10]
[0 - 1]
[0 - 1]
[0 - 3]
[0 - x]
[0 - 3]
[0 - 3]
[0 - 3]
[0 - 3]
[0 - 3]
[0 - 3]
-
-
-
-
[0 - 1]
Coasting Select
Control Source
will not change but the frequency converter will trip and display:
8 Parameters
Dat a t ype:
- 5
- 5
1 7
- 5
- 5
- 5
- 5
- 5
- 5
- 5
- 5
- 5
- 5
- 5
8
- 10
- 5
- 6
- 9
- 5
Preset
to par.8-56
Option A [3] if it
FC
back to default setting
49