Danfoss VLT FC 100 Manual page 33

VLT® FC 100 LonWorks
ECB Opt ion St at us
Var iable
nam e:
nvoECBStatus
This variable displays the current status of the ECB option.
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bit 10
NB!
These variables are available only if the
Par am et er Access Response
Var iable nam e:
nvoParamResponse
This output variable is used for the frequency converter access.
A special UNVT has been defined for this variable.
For more information on parameter access, please refer to the
SNVT
t ype:
SNVT_state
Electronic Control By-pass option
How to Access FC 100 Parameters
®
MG.11.E2.02 - VLT is a registered Danfoss trademark
5 Configuration of the system
St at e:
Boolean 1 bit x 16
Test Mode
Drive Mode
Automatic By-pass Mode
By-pass Mode
Reserved
Motor Running from By-pass/Drive
Overload Trip
M2 Contactor Fault
M3 Contactor Fault
External Interlock
Manual By-pass Override
(ECB) has been installed.
SNVT t ype:
UNVT_param_response
section.
5
33