Verifying Operating Status; Setting Up The Configuration Environment; Connect To Network Cables; Log In To The Web Interface For Setup - Ruijie Networks Reyee RG-NBS3100-8GT2SFP-P-V2 Installation Manual

Installation Guide
4

Verifying Operating Status

4.1

Setting Up the Configuration Environment

4.1.1

Connect to network cables


Plug one RJ45 connector of the Ethernet cable into the Ethernet port of the PC.

Connect the other RJ45 connect to any port of the switch.
4.1.2

Log In to the Web Interface for Setup

(1) Configure your PC with an IP address in the network of 10.44.77.XXX (Range: 1-255, excluding 200).
(2) Open a browser on the PC, then enter 10.44.77.200 to go to the web interface of the device. You can use
the default password "admin" for login for the first time. To ensure security, you are advised to change the
password after login, and update the password regularly.
4.2

Powering On

4.2.1

Checklist Before Power-on


The switch is connected to earth ground.

The power cord is properly connected.

The input voltage meets the requirement.

The Ethernet cable is properly connected. The terminal (it can be a PC) used for configuration is already
started. The parameters are configured correctly.
4.2.2

Checklist After Power-on

After the AP is powered on, check the following items to ensure the normal configuration:

Indicators of the switch are in the normal state.

The main program is loaded properly.

Service ports can forward data properly.
19
Verifying Operating Status