Page 2
锐捷以太网交换机快速安装指南 Ruijie Ethernet Switch Installation Quick Start 设备安装 Install the switch 安装前准备 Preparing for installation 安装到桌面:防静电手套(或手环) Mounting on the desktop: ESD bracelet or gloves 安装到 19 英寸标准机架:防静电手套(或手环) 、螺丝刀、螺钉 Mounting to a standard 19-inch rack: ESD bracelet or gloves, screwdriver, screws 安装到桌面...
Page 3
用包装盒内的螺钉将两个 L 型支架分别固定到交换机的两侧。 Fix the 2 L-shaped brackets to both sides of the switch with the included screws. 将交换机放置于机架内的适当位置,用螺钉(需自备)将 L 型支架固定到机架两侧的 导槽上,确保交换机平稳地安装到机架上。 Mount the switch at a proper height on the rack and fix the L-shaped brackets to the rack with the screws (not included). Ensure that the switch is stable on the rack.
设备连接 Connect the switch 本交换机支持端口自动翻转(Auto MDI/MDIX) ,用网线连接交换机与对端以太网设备时,使用直连线 或交叉线均可。 警 告 此为 A 级产品,在生活环境中,该产品可能会造成无 线电干扰,在这种情况下,可能需要用户对干扰采 取切实可行的措施。 Tips This switch supports auto MDI/MDIX, so both a straight cable and a crossover cable can be used to connect the switch to Ethernet devices.
Page 5
Warning This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. 请参考下表检查设备连接是否正确或调节交换机工作模式。 Please check whether the switch is connected properly or adjust the operating mode of the switch according to the following table.
Port Isolation: In this mode, ports 1 to 24 cannot communicate with each other, but can communicate with ports 25, 25F, 26 and 26F respectively, which helps isolate DHCP broadcast and reduce broadcast storm. 规格参数 Specifications 产品型号 RG-ES126S 10/100Mbps RJ45 端 口 10/100/1000Mbps RJ45 端口 端口 SFP 端口...
Page 7
产品型号 RG-ES126S 以太网:3 类或以上 UTP/STP 快速以太网:5 类或以上 UTP/STP 网络介质 千兆以太网:建议使用超 5 类或 6 类 UTP/STP 1000Base-SX:MMF(多模光纤) 1000Base-LX:MMF(多模光纤)或 SMF(单模光纤) 网络标准 IEEE 802.3、IEEE 802.3u、IEEE 802.3ab、IEEE 802.3x GB9254-2008 安规 GB4943-2011 Product model RG-ES126S Number of 10/100 Mbps RJ45 port Number of 10/100/1000 Mbps RJ45 port...
Need help?
Do you have a question about the RG-ES126S and is the answer not in the manual?
Questions and answers