Preparing For Installation; Safety Precautions; General Safety Precautions; Handling Safety - Ruijie Networks Reyee RG-NBS3100-8GT2SFP-P-V2 Installation Manual

Installation Guide
2

Preparing for Installation

2.1

Safety Precautions

Note
To avoid bodily injury and device damage, please carefully read the safety precautions before you install the
device.
The following safety precautions may not cover all possible dangers.
2.1.1

General Safety Precautions


Install the device in a standard 19-inch rack, and ensure that the rack and power distribution system are
properly grounded.

Do not place the device in a wet area, and keep it away from liquid. Keep the chassis clean and dust-free.

Keep the device away from heat sources.

Do not place the device in walking areas.

During installation and maintenance, do not wear loose clothing, jewelry, or any other objects that may hook
onto the chassis.

Do not place tools and accessories in walking areas.
2.1.2

Handling Safety


Avoid handling the device frequently after the device is installed.

Prior to installation or dismantling, turn off all power supplies and disconnect all power cords and cables.

Moving the device requires a team of at least two people. Operating alone is strictly prohibited. Pay attention
to maintaining balance to prevent injuries.
2.1.3

Electrical Safety

Warning

Any nonstandard and inaccurate electrical operation can lead to accidents such as fires or electric
shocks, causing severe, or even fatal damage to the human body and the device.

Direct or indirect touch through a wet object on high-voltage and mains supply can bring a fatal danger.

Observe local regulations and specifications when performing electrical operations. Only qualified personnel
should handle these tasks.

Carefully check the work area for potential hazards, including ungrounded power system, insufficient
grounding, and damp or wet ground.

Locate the emergency power supply switch in the room before installation. In the case of an accident, cut off
the power supply immediately.

Carefully inspect the device and the environment before powering on or off the device.
6
Preparing for Installation