Hypertherm Powermax45 SYNC Operator's Manual page 103

Fault Fault
code LEDs
0-11-0 CNC use
ON
0-11-1
ON
0-11-2
ON
Powermax45 SYNC Operator Manual
Torch
LEDs Description
The remote control
only operating mode is incorrect
or not permitted for the
installed cartridge.
The permitted operating
modes for cutting
cartridges are 1 (Cut
mode). The permitted
operating mode for a
gouging cartridge is 2
(Gouge mode).
The remote control output
current (A) is incorrect or
not permitted for the
installed cartridge.
The permitted values relate
to the minimum and
maximum output current (A)
for the plasma power
supply and the installed
cartridge.
The remote control gas
pressure is incorrect or not
permitted.
The permitted gas pressure
relates to the selected
process and operating
mode, and to the installed
torch, torch lead, and
cartridge.
811470
Troubleshoot Common Problems
Solutions
These fault codes only apply to remotely
controlled plasma power supplies. They do not
stop the system from operating.
There is a problem with the remote control or
the software interface to the system. The system
cannot interpret the operating mode, output
current, or gas pressure information coming
from the controller.
• Examine the programming code for
incorrect process variables.
• Repair the controller.
6
103