Prepare To Fire The Torch - Hypertherm Powermax45 SYNC Operator's Manual

5
Gouge with the Hand Torch

Prepare to fire the torch

INSTANT-ON TORCHES – PLASMA ARC CAN CAUSE INJURY, BURNS
Ignition of the plasma arc occurs immediately when you pull the torch trigger. Before
changing the cartridge, one of the following steps is necessary. Whenever possible,
complete the first step.
Set the power switch on the plasma power supply to OFF (O).

Move the torch-lock switch to the yellow lock (X) position. Pull the trigger to make

sure that the torch does not fire a plasma arc.
INSTANT-ON TORCHES – STAY CLEAR OF PLASMA ARC
The plasma arc will cut quickly through gloves and skin.
Put on the correct and approved protective equipment.

Keep hands, clothing, and objects away from the torch tip.

Do not hold the workpiece. Keep your hands clear of the cutting path.

Never point the torch toward yourself or others.

78
WARNING
OR
WARNING
WARNING
RISK OF BURNS AND ELECTRIC SHOCK – USE INSULATED GLOVES
Always put on insulated gloves when changing the cartridges. The cartridges
get very hot during cutting and can cause severe burns.
Touching the cartridges can also cause electric shock if the plasma power
supply is ON and the torch-lock switch is not in the yellow lock (X) position.
811470 Operator Manual Powermax45 SYNC