Tools Needed For Installation - SSV Works RG4-Q3A1 Manual

PANELS AND DASH DISASSEMBLY
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or workmanship.
All SSV Works Electronics are covered by a limited 1 year warranty against defects in material or workmanship.
All Kicker Speakers are covered by a limited 1 year warranty against defects in material or workmanship. All
Kicker Amplifiers are covered by a limited 1 year warranty against defects in material or workmanship. Labor for
replacement of defective components is not covered. Contact SSV Works for further warranty information.

TOOLS NEEDED FOR INSTALLATION

A. Remove hood by turning locking pins and lifting up.
C. With push pins extracted, lift to remove the cup holder.
E. Unscrew (4) torx screws located in upper glove box and
remove box.
- T-40/30/25 Torx Driver - Phillips Screwdriver - Drill - 3/32" Bit
A
B. Use a panel tool to extract push pins circled in pink.
C
D. Lift and disconnect gauge cluster for removal.
E
F. Extract push pins that are now exposed from removing the
upper glove box.
3
Please read and understand these
!
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
- 9/16" Bit - Uni-Bit
B
D
F