Configuring An Email Server - Check Point HARMONY R81 Administration Manual

n Trigger alert when the condition reaches - When the initial alert message is sent.
n Optional: After the alert was triggered, turn off when less than - When an alert
resolved message is sent.
4. In the Notification Settings area, select which type of messages to send:
n Select Notify on alert activation to send an Initial Alert message.
Clear to disable initial alerts.
n Select Notify on alert resolution to send an Alert Resolved message when
applicable.
Clear to disable Alert Resolved messages.
n Select an Alert Reminder frequency from the Remind every list.
Select None (default) to disable reminders.
5. In the Add New Recipient field, enter an email address for recipients who will get the
alerts.
6. Click Add.
7. Click OK.

Configuring an Email Server

You must configure your email server settings for the Security Analysis to send alert email
messages. If you use Capsule Docs it is also important to configure this. The settings include
the network and authentication parameters necessary for access to the email server. You can
only define one email server.
To configure the email server:
1. In SmartEndpoint, select Manage > Email Server Settings > Configure Settings.
2. In the Email Server Settings window, enter the email server host name or IP address.
3. Select the Port number for the email server (default = 25).
4. If the email server requires an SSL connection, select Enable SSL Encryption.
5. If email server authentication is necessary, select User authentication is required and
enter the credentials.
6. Click Send Test Email to make sure that you can successfully access the email server.
7. In the window that opens, enter an email address that the test will be sent to and click
Send.
Monitoring Endpoint Security Deployment and Policy
R81 Harmony Endpoint Server Administration Guide | 60