Check Point HARMONY R81 Administration Manual page 171

4. In the General Properties page of the window that opens, enter a unique name and an
IP address for the server.
5. In the Management tab of the General Properties page, select Network Policy
Management.
Secondary Server, Logging & Status, and Provisioning are selected automatically
DO NOT enable Endpoint Policy Management on the server.
6. Click Communication to create SIC trust between the Secondary Endpoint Security
Management Server and the Primary Endpoint Security Management Server.
7. In the window that opens enter these configuration parameters:
n One-time password (twice to confirm) - SIC Activation Key that you entered in the
Check Point Configuration Tool
n Click Initialize to create a state of trust between the Endpoint Security
Management Servers. If the trust creation fails, click Test SIC Status to see
troubleshooting instructions
n If you must reset the SIC, click Reset, then reset the SIC on the Secondary server
and click Initialize.
8. Click Close.
9. Click OK.
10. From the menu, select Install Database.
11. Wait for the peer initialization and the full sync with peer to finish.
To enable Endpoint Security on the secondary server:
1. After the previous procedure is completed, in SmartConsole, open the secondary server
object.
2. In the Management tab of the General Properties page, select Endpoint Policy
Management.
3. Click OK.
4. Select File > Save.
5. From the menu, select Install Database.
6. Follow the steps in
next page
.
"Synchronizing MSI Files, Dynamic Packages and Drivers" on the
R81 Harmony Endpoint Server Administration Guide | 171
Management High Availability