Check Point HARMONY R81 Administration Manual page 282

To configure the Active Directory server as the primary DNS server in Gaia:
a. In the Portal, Network Management navigation tree menu, select Hosts and
DNS.
b. Enter the IP address of the Active Directory server as the Primary DNS Server.
c. Click Apply.
To configure the Active Directory server as the primary DNS server in Windows:
a. In the Control Panel window, go to Network and Internet > Network and
Sharing Center > Change adapter settings.
b. Right-click the server network interface and select Properties.
The Connection Properties window opens.
c. Select Internet Protocol Version 4 (TCP/IPv4) and click Properties.
d. In the window that opens, enter the IP address of the Active Directory server as
the Preferred DNS server.
e. Click OK.
f. Click Close.
3.
Configure the Directory Scanner
"Active Directory Scanner" on page 93
See
Directory Scanner.
4.
Prepare the Reverse Proxy
The Reverse Proxy makes sure that requests from mobile devices and Capsule Docs
clients that do not have internal network access reach the Endpoint Security Server.
If you use a Security Gateway as the Capsule Docs Reverse Proxy, do the procedures
in this section. Alternatively, you can configure a third party server, for example an
Apache Server, as a Reverse Proxy Server. See
as a Reverse Proxy Server.
To prepare the Security Gateway for the Capsule Docs Reverse Proxy you must:
for instructions on how to configure the
sk102973
R81 Harmony Endpoint Server Administration Guide | 282
Capsule Docs
to use a third party server