Changing Parameter Settings Or Values; Verifying Parameter Changes: Verify Menu - Omron J1000 User Manual

The Setup Group within the Programming Mode
In Setup Group, the user can access the minimum group of parameters required to operate the application.
Note: Setup Group parameters are listed in
Figure 4.5 illustrates the keys to press to enter the Setup Group.
In this example, the source of the frequency reference is changed from the control circuit terminals to the LED Operator
(i.e., b1-01 is changed from 1 to 0).
u

Changing Parameter Settings or Values

This example explains changing C1-01 (Acceleration Time 1) from 10.0 seconds (default) to 20.0 seconds.
1. Turn on the power to the drive. The initial display appears.
2. Press the
key until the Setup Mode Screen appears.
3. Press the
key to view the parameter setting display.
4. Scroll through parameters by pressing the
5. Press
to view the current setting value (10.0). (Number farthest to the left flashes)
6. Press
until the desired number is selected. ("1" flashes)
7. Press the
key and enter 0020.0.
8. Press
and the drive will confirm the change.
9. The display automatically returns to the screen shown in Step 4.
10. Press the
key until back at the initial display.
u

Verifying Parameter Changes: Verify Menu

The Verify Menu lists edited parameters from the Programming Mode. The Verify Menu helps determine which settings
have been changed, and is particularly useful when replacing a drive. If no settings have been changed the Verify Menu
will read . The Verify menu also allows users to access and re-edit edited parameters.
Note: The Verify Menu will not display parameters from the A1 group even if those parameters have been changed from default settings.
SIEP C710606 33A OYMC AC Drive – J1000 User Manual
Table 4.4.
Frequency reference
appears when powered up
Press until
STOP
appears
<1>
Parameter Display Control Circuit
Terminal
STOP
STOP
<1> Move to the right to change parameter settings. Scroll
down to view and check settings in the Setup Mode.
STOP
<2> To return to the Top Menu, press
other parameters, press
STOP
Figure 4.5 Setup Group Example
Step
key until C1-01 appears.
4.3 The Drive and Programming Modes
LED Operator
Select digit
to edit
<2>
Parameter Display
(2x)
. To view or edit
and .
Display/Result
59
4