Interlocking With Connected Machinery; Interlocking With Connected Machinery; Drive Ready Signal - Omron J1000 User Manual

3.11 Interlocking with Connected Machinery

3.11 Interlocking with Connected Machinery

For safety reasons, applications that may be affected by the operation status of the drive should be set up so that operation
can only occur when the drive is ready to operate. A "Drive ready" and "Fault" signal should be assigned to the multi-
function outputs to guarantee interlock with application.
u

Drive Ready Signal

The "Drive ready" signal is output to one of the multi-function terminals after the drive has booted up and there is no fault
present. It indicates that the drive is ready for operation.
• The power is off.
• A fault situation is present.
• There is a problem with the drive internal power supply.
• Parameter settings restrict a Run command from being entered.
• An overvoltage or undervoltage situation is present so that when the Run command is given a fault is immediately
triggered.
• The drive is in the programming mode and parameter settings restrict a Run command from being entered in the
programming mode.
48 SIEP C710606 33A OYMC AC Drive – J1000 User Manual