HikRobot SC6000 Series Quick Start Manual page 14

No. Signal
8 RS232_R
9 OPTO_IN0
10 OPTO_IN1
11 IN_COM
12 OPTO_OUT0 Line 4 Signal Line
13 OPTO_OUT1 Line 5 Signal Line
14 OUT_COM
15 GPIO0
16 GPIO1
17 GND
The supplied power and I/O cable in the device's package is shown below.
Note
● The light source output corresponding to 5
into a SMR-03V-B type of light source interface by default. The light source device can
be directly connected without wiring.
● For the open part of the cable corresponding to other pins, please wire according to the
description of each pin in the table above.
SC6000 Series Smart Camera Quick Start Guide
I/O Signal Source
--
Line 0 Signal Line
Line 1 Signal Line
Line 0/1 Signal
Ground
Line 4/5 Signal
Ground
Line 2 Signal Line
Line 3 Signal Line
Line 2/3 Signal
Ground
Figure 3-3 Power and I/O Cable
Description
RS-232 Input
Opto-isolated Input 0
Opto-isolated Input 1
Input Signal Ground
Opto-isolated Output 0
Opto-isolated Output 1
Output Signal Ground
Configurable Input/Output, Output
by Default
Configurable Input/Output, Output
by Default
Configurable Input/Output Signal
Ground
th th
pin and 6 pin in the cable has been made
8
Cable Color
Gray/Pink
Blue
Red
Purple
Green
Yellow
Pink
Black
Orange
Gray