Fitting/Connecting The System Components; Installing And Connecting The Tool Table And Other System Components - Fronius Virtual Welding 2.0 Operating Instructions Manual

Fitting/connecting the system components

Installing and
connecting the
tool table and
other system
components
NOTE!
The position of the workpiece holder (1) shown corresponds to the standard
mounting position. The workpiece holder (1) can be mounted in other positions
on the tool table. These are shown at the end of the section.
1
2
Place the workpiece holder (1) on the tool table
- To do so, make sure that the workpiece holder is locked in the guides (2)
Connect the workpiece holder sensor cable to the Virtual Welding system
(2) (2)
(1)
(2) (2)
(2)
(2)
41