Fieldbus Cable Connections; Prerequisites For Installation; Communication Interface X1/X2 In Frames Fa02-Fa12; Communication Interface X1/X2 In Frames Fk06-Fk12 - Danfoss iC7-Hybrid PROFINET Operating Manual

Hide thumbs Also See for iC7-Hybrid PROFINET:

Table of Contents

Operating Guide | iC7-Hybrid PROFINET

Fieldbus Cable Connections

3.1

Communication interfaces are integrated in the control board in iC7 drives and power converters.

The position of the connections differs based on the control board concept and frame, for example. For more information on the location

of the connections, cabling, and shielding, refer to the product-specific design guide.

Communication Interface X1/X2 in Frames FA02–FA12

3.2

The communication interface is on the top of the frequency converter as shown in

recommended for optimal connection. A combined shield/fixing plate, the Fieldbus EMC plate, is available as an accessory to strengthen

the mechanical fixation of the cables.

Figure 5: Location of the Communication Interface, X1/X2 in FA02-FA12 Frames (with the Optional EMC Plate)

Communication Interface X1/X2 in Frames FK06–FK12

3.3

The communication interface ports are located inside the frequency converter. The position of the ports and the recommended wiring

path are shown in

Figure 6

and

X 1X 2

Figure

5. Industrial-grade RJ45 connectors are

AQ481922002453en-000101 / 172K4283A

Table of Contents

Do you have a question about the iC7-Hybrid PROFINET and is the answer not in the manual?