Table of Contents
Advertisement
Appendix B: Installer Menu Map
Important: The defaults listed below enable the panel to comply with EN50131 requirements. If
you change those settings, the installation may no longer comply. If the panel does not comply
with EN50131, you must remove any labelling that indicates compliance.
Some options are available only if the relevant hardware is fitted, or for certain models of panel.
MENU Option
1 Detectors/Devices
Program Zones
Detectors
Address Bus
Device
Address Bus Device
Wired Keypads
Edit Keypad
Delete Keypad
Enable Keypad
Replace Keypad
Replace Keypad
2 Outputs
Panel
Wired outputs
Zone 0...
Name
"Zone n"
Type
Not used
Attributes
All "off"
Keypad Kn-51...
Name
"Keypad Kn-nn".
Key A
Name: "Key A"
Action: Full Set
Name: "Key B"
Key B
Action: Part Set B
Name: "Key C"
Key C
Action: Part Set C
Key D
Name: "Key D"
Action: Part Set D
Loudspeaker Volume
Buzzer Volume
Backlight
Enabled
Internal Prox
Disabled
External Prox
Yes (all keypads enabled)
EDIT output
Name
Type
For outputs 1 and 3, the default
"Type" is "Siren". For output 2, the
default "Type" is "Strobe".
Normal
Polarity
No
Latched
No
Pulsed
Delay
0 seconds
On Time
1 second
Zones
None
Factory Default
Available when zone is given a type
other than "Not Used".
Some attributes are only available on
particular zone types.
Double Knock does not comply with
EN51031.
Available only when a suitable keypad is
fitted.
For User-Defined output type.
Not available for dedicated siren and
strobe outputs.
Available when Pulsed set to "Yes".
Available only for Zone Follow and Zone
Alarm output types.
Notes
66
Advertisement
Table of Contents
