Table of Contents
Advertisement
Step 7: Connect all wired devices
Connect all wired devices except the battery, as shown in Figure 6 on page 21.
Step 8: Connect the Battery:
Note: Connecting the battery does not start the system.
Fit a 7Ah lead-acid battery in the bottom-left corner of the panel.
Connect the battery leads to the battery (red to positive and black to negative) and connect the
transformer lead to the PCB (Figure 6 on page 21).
Step 9: Connect the mains cable
WARNING: ENSURE THAT THE MAINS SUPPLY IS DISCONNECTED AND ISOLATED!
Connect the mains cable to the terminal block (Figure 10) and fit a strain-relief tie. Do not apply
power until after the lid is re-fitted.
Figure 10 – Mains connections
Step 10: Re-fit the lid, switch on and configure the system
WARNING: During initial power-up, keypad sounders and any internal loudspeaker may
give an alarm tone. If you are working at the top of a ladder, make sure that the sudden
noise does not startle you and cause a fall.
Re-fit the lid, then switch on the mains supply to the panel.
Go through the initial configuration prompts and set up the system as described in Configuring
the System on page 27. You are prompted to specify installer and user codes during initial system
configuration.
26
Advertisement
Table of Contents
