Table of Contents
Advertisement
Step 5 Mount the panel
Mount the panel in the orientation shown in
Figure 8 - Fixing holes and cable entries
using the three fixing holes and minimum 40m long No8 (4mm) screws. Use only the designated
fixing holes.
Signal cable entry
Mains terminals
Mains cable entry
Signal cable entry
Fixing holes
Figure 8 - Fixing holes and cable entries
Step 6: Position the communicator and fit the fourth pillar
If a communicator is used, position it under the PCB.
Fit the supplied fourth pillar for the PCB (see Figure 2) and secure the PCB to the pillar using the
supplied M3x12 screw.
Fit supplied pillar
Figure 9 – Fitting the fourth pillar
25
Advertisement
Table of Contents
