Philips PerfectCare Performer GC8755/80 User Manual page 8

English
10
Problem
The Calc-Clean process
does not start.
The iron leaves a shine
or an imprint on the
garment.
The ironing board cover
becomes wet, or there
are water droplets on the
floor/garment.
Possible cause
You have not pressed the
CALC-CLEAN button for
2 seconds until the appliance
started beeping.
The surface to be ironed was
uneven, for instance because
you were ironing over a seam
or a fold in the garment.
There was not enough felt in
the ironing board cover.
Steam has condensed on the
ironing board cover after a
long ironing session.
You have an ironing board
that is not designed to cope
with the high steam rate of
the appliance.
Solution
See chapter 'Cleaning and maintenance'.
PerfectCare is safe on all garments. The shine
or imprint is not permanent and will come off
if you wash the garment. Avoid ironing over
seams or folds or you can place a cotton cloth
over the area to be ironed to avoid imprints.
Put an extra layer of felt material under the
ironing board cover.
Replace the ironing board cover if the foam
or felt material has worn out. You can also
add an extra layer of felt material under the
ironing board cover to prevent condensation
on the ironing board.
Put an extra layer of felt material under the
ironing board cover to prevent condensation
on the ironing board.