Philips CRYSTAL 650 User Manual page 13

Hide thumbs Also See for CRYSTAL 650:
Table of Contents

Advertisement

Loading Paper
Use only undamaged paper that is suitable for use with
inkjet printers.
²
Do not use any paper lighter than 75 g/m
ensure good printing quality.
1
Separate the paper sheets by fanning them out,
then align them by tapping edge of the stack lightly
against a flat surface. This will prevent several sheets
of paper from being drawn in all at once.
Lift up and hold the printout tray. Pull the front
2
paper guide as far out as it will go. Lay a maxi-
mum of 150 sheets of paper (standard format A4,
210×297 mm, 80 g/m
the short edge out, inserting them up to the
stop.
Æ
The capacity of the paper tray depends on the
thickness of the printing medium loaded. In-
sert a stack no higher than the height limit of
the two side paper guides (see indicator marking
printed on the machine).
3
Enclose the paper with the two side paper
guides ...
1. Installation
2
to
2
) into the paper tray with
... and the front guide. Be sure not to enclose it so
tightly that it bends.
4
Carefully return the printout tray back to its origi-
nal position.
Instructions on the Use of Paper
²
Follow the instructions of the paper manu-
facturer for using the paper correctly.
¿
To prevent paper jams and poor printing quality, do
not use moist or damaged paper. Do not add paper
while the machine is printing. If the paper curls in the
printout tray after printing, remove it immediately. In-
structions for removing a paper jam can be found in the
chapter Troubleshooting / Removing a Paper Jam.
Æ
Never open the paper jam door while the
multifunction machine is printing.
¿
Only insert paper when the paper tray is empty.
Avoid mixing loaded paper and new paper—par-
ticularly with different paper types.
¿
Printouts with high printing density (e.g. due to
complex graphics) can remain damp for a longer
time. Leave the printout in the printout tray for 30 to
60 seconds to dry.
Loading Photo Paper
²
The original photo paper was specially de-
signed for your multifunction machine in or-
der to achieve the best possible printing quality
and durability. If you use other types of paper, it
is possible that the paper could be drawn in in-
correctly or the ink could smudge. You can order
original photo paper from our order service (see
the back side of this user manual).
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Crystal 660Crystal 665

Table of Contents