Table of Contents
Advertisement
Chapter 5 – Configuration
Enter alert
settings
Check and
adjust advanced
settings
RAID configuration
Set system
parameters
Set array
parameters
Set system
parameters
The administrator can specify up to two fax numbers and two
pager numbers to which alert messages will be sent in the
event of an error with ACS-9910. Turn to Entering and editing
alert settings.
The default settings are appropriate for most users. Turn to
Advanced settings. Then proceed with RAID configuration.
Turn to Setting system parameters and define:
The number of hosts
The number of active slots (hard disks)
Striping block size
The plug mode
Turn to Setting array parameters and set the following
individual parameters for each array:
RAID level
Number of disks
Number and size of slices
Write buffer (enable/disable)
The Setting array parameters section is where to turn to delete,
reconfigure or set new array parameters
Set the following parameters for the RAID system:
Striping block size
Write buffer (enable/disable)
Writing method (Random / sequential)
35
Advertisement
Table of Contents
