Table of Contents
Advertisement
4. Configuring ACS-8910
The following sections describe how to configure the ACS-8910. To configure the ACS-8910 you
must configure the RAID settings and the SCSI settings. After these two steps are completed the
ACS-8910 will perform as a normal SCSI hard disk to the host system.
4.1 Initial RAID Configuration
This section provides instructions on how to setup a RAID configuration by using the front control
panel of the ACS-8910. Alternatively, the RAID configuration can be set up from the remote
terminal or the terminal emulation program that can be found on your computer. Refer to section 6
Monitor Utility for more details on RAID configuration by using the RS-232 port and monitor
utility.
For
Quick Setup
Single Host
Dual Host
4.1.1 Quick Setup
Turn on the ACS-8910 from power supply switch.
1.
Press the [ENT] button to display the "Main Menu" menu.
2.
Press the [ENT] button to open the "0 Quick Setup" menu.
3.
Repeatedly press the [▼] button until the "01 Quick Setup" menu
4.
is displayed then press the [ENT] button.
Repeatedly press the [▼] button until the "011 Reconfirm" menu
5.
is displayed, then press the [ENT] button.
Select "Yes" to change an existing RAID configuration.
6.
Section
4.1.1
4.2.1
4.2.4
26
Advertisement
Table of Contents
