Turning On For The First Time; Turning Off; Restarting - Accusys ACS-9910 User Manual

Turning on for the first time

When cabling is complete, ACS-9910 can be turned on. This should be done in the following
order:
1. First turn on the power source
2. Then boot the host computer(s)
When ACS-9910 is running, you are ready to configure one or more arrays. You have the
following options:
1. Turn to Chapter 3 to perform a quick setup of a single RAID using the control panel.
2. Turn to Chapter 4 to access the Monitor Utility. Once the Monitor Utility is accessed, you
can perform a Quick Setup (Chapter 3) or complete configuration (Chapter 5) with either
the control panel or Monitor Utility.
Turn to Chapter 5 to perform a full configuration using the control panel.

Turning off

When turning off ACS-9910, users are advised to first shut down the server, then power off
ACS-9910.

Restarting

When restarting ACS-9910, users are advised to first restart the server, then power on
ACS-9910.
26
ACS-9910 User's Manual