Setting Connection Parameters; Edit Chan Menu - Accusys ACS-9910 User Manual

Setting connection parameters

Use this section to define the configuration of the host and controller device channels.

Edit Chan Menu

4 Edit Chan 4.1 Host Chan 1
4.2 Host Chan 2*
*submenus as for
Host Chan 1
4.3 Disk Chan 1
4.4 Disk Chan 2**
**submenus as for
Disk Chan 1
4.1 4.2 Host Channel
~
Select a host channel to configure
4.1.1 Set SCSI ID
Select 0 to 15 or Multiple (Default: 0). ID 7 is usually reserved for the host SCSI
card.
4.1.2 Termination
Enable or Disable (Default: Enable). Disable termination if a terminator has
been installed on each SCSI bus
44
4.1.1 SCSI ID
4.1.2 Termination
4.1.3 Tag queuing
4.1.4 Wide
4.1.5 Speed
4.1.6 ~ 4.1.D LUN
map
4.3.1 Wide
4.3.2 Speed
ACS-9910 can be set up with two host channels and two disk channels, or a
single host channel and up to three disk channels. Turn to Setting System
Parameters earlier in this chapter for details.
If ACS-9910 is the only SCSI device on the bus or is at the end of a daisy chain
the termination should be enabled. If ACS-9910 is in the middle of a daisy
chain the termination should be disabled.
ACS-9910 User's Manual
0~15 / Multiple
Enable / Disable
Enable / Disable
Enable / Disable
Ultra 3 / Ultra 2 / Ultra /
Fast
LUN 0 ~LUN 8
Enable / Disable
Ultra 3 / Ultra 2 / Ultra /
Fast