Quick Setup With The Control Panel - Accusys ACS-9910 User Manual

Quick Setup with the control panel

1. Turn on ACS-9910. The controller will enter
self-diagnostic mode and automatically enter
Operation Mode. A typical operation mode screen is
shown.
2. Press Enter to enter configuration mode. You will be
prompted to enter the Password. The default
password is 00000000 (eight zeros). To enter this,
simply press Enter eight times. Press Enter again to
submit.
3. You enter the Main Menu. The first item on the main
menu is the Edit Chassis submenu. Scroll down to
the second item in the Main Menu: Quick Setup.
Press Enter to select.
4. The Quick Setup submenu lists the RAID levels
available (0, 1, 3, 5 and 0+1). Scroll through the list
until the appropriate RAID level for the array you
want to set up is showing. Press Enter.
5. You will be prompted to select the number of disks
for inclusion in the RAID. The minimum number of
disks for that level array will be shown.
6. Finally, you will be prompted to confirm your choice.
Select Yes and press Enter to complete Quick
Setup.
28
Full explanation of the control panel messages is given in Appendix C.
Instructions on using the control panel are given in the section Control Panel
in Chapter 1
The contents of all submenus other than Quick Setup are explained in detail in
Chapter 5.
Full explanation of the different RAID levels available is given in Appendix B.
Quick Setup cannot be used to set up more than one array.
ACS-9910 User's Manual
ACS-9910
NO RAID
Enter Passwd:
0▓▓▓▓▓▓▓
Main menu
1 Edit Chassis
2 Quick Setup
21 Level 5
2 Quick Setup
211 Disk Num 3