Table of Contents
Advertisement
Configuration Mode
Configuration Mode enables the RAID administrator to configure and modify the settings of
ACS-9910 and fine-tune the configuration. Configuration Mode is entered from Operation
Mode:
1. When the Enter button on the controller box is pressed
2. When the Monitor Utility is invoked from the remote terminal.
Full details on changing configurations are given in Chapter 5
Operation Mode
Operation Mode is the default state of ACS-9910. In this mode, the controller box front panel
LCD continuously displays the current status of ACS-9910. A full explanation of control panel
LCD messages is given in Appendix C.
Two Configuration Utilities
There are two ways to configure ACS-9910, namely using the LCD Control Panel and through
terminal emulation.
User-Friendly LCD Control Panel
ACS-9910 can be configured directly using the LCD control panel.
VT-100 Terminal Emulation (HyperTerminal)
This embedded menu-based configuration utility is accessed through the host computer
terminal.
12
ACS-9910 should be off-line and not being accessed by any application when
Configuration Mode is run.
ACS-9910 will automatically switch from Configuration Mode to Operation
Mode after 3 minutes if no buttons are pressed on the controller box control
panel and no action is taken on the Monitor Utility
ACS-9910 User's Manual
Advertisement
Table of Contents
