Table of Contents
Advertisement
Installing SODIMM
To install a SODIMM, ensure the system power is off and disconnected. Then:
1. Remove any screws securing the
controller box cover, then slide the cover
back and lift off.
2. Remove the daughter board (if any has
been installed).
3. Insert a memory card at a 45-degree angle
into the memory card socket so that the
gold teeth of the card are no longer visible.
4. Press the card down firmly until the latches
lock it into place.
Removing SODIMM
1. Remove the daughter board (if any has
been installed).
2. Release the latches securing the SODIMM
to the controller board. The SODIMM will
pop up.
3. Lift the SODIMM gently out of the memory
card socket.
Changing Components
Removing / replacing control panel
To remove the control panel:
1. Remove the daughter board (if any has
been installed).
2. Release the two control panel cables from
the control panel.
3. Release the two latches securing the
control panel to the controller box casing.
4. Ease the control panel forward out of the
controller box.
To install the control panel:
1. Connect the two control panel cables to the control panel.
2. Slot the control panel into position, ensuring that the two latches lock the control panel
into position on the controller box casing.
22
ACS-9910 User's Manual
Advertisement
Table of Contents
