Installation
Align the safety switch and mounting bracket with the
actuator and tighten the screws.
8.3
Installing on a sliding gate
This chapter shows the graphics of the PSEN sl2‑L‑AL actuator.
Unless stated otherwise, the information also applies to the PSEN sl2‑L‑VA actuator.
Align the actuator mounting bracket flush with the sliding gate
and tighten the screws.
Install the actuator at the height required.
Align the safety switch mounting bracket flush with the frame and
fasten with screws.
(Important: Do not tighten the screws.)
Fix safety switch upright with a screw, close gate.
Align mounting brackets, press firmly together and tighten screw.
Remove the safety switch and tighten screw.
Align the safety switch to the actuator and tighten the screws.
Operating Manual PSEN sl2-IL1/2/3-P
1005909-EN-02
| 37