Table of Contents
Advertisement
6.18
Control panel
6.18.1 Using the push assist system
CAUTION
!
Injury from pedals or wheels
The pedals and the drive wheel turn when the
push assist system is used. There is a risk of
injury if the pedelec wheels are not in contact with
the ground when the push assist system is used
(e.g. when carrying the pedelec up stairs or when
placing it on a bicycle rack).
Only use the push assist mode when pushing
the pedelec.
You must steer the pedelec securely with both
hands when using push assist.
Allow for enough freedom of movement for the
pedals.
The push assist helps move the pedelec. The
speed is a maximum of 6 km/h in this case.
The drive system is switched on.
Figure 158: Position of push assist button
1 Press the push assist button briefly.
The push assist mode is switched on.
2 Press and hold the push assist button again
within 3 seconds.
Push assist is activated.
MY24K12 - 13_1.0_01.02.2024
3 Release the push assist button to switch off
the push assist system.
4 Push assist mode switches off if the push
assist button is released for ten seconds.
Push assist mode will also switch off
automatically if the speed exceeds 6 km/h.
Using the riding light
6.18.1.1
Figure 159: Position of riding light button
The drive system needs to be already switched
on to turn on the riding light.
Press the riding light button.
The lighting modes change in the following order:
1
Table 49: Overview of riding light symbols
Operation
1 dimmed headlight (only applies to
pedelecs with this equipment)
2. Main beam (only applies to pedelecs
with this equipment)
3. Light off
1
162
Advertisement
Table of Contents
