Kettler KN170 PD Series Translation Of Original Operating Instructions page 141

Connecting the Komoot app
The Komoot app can be connected to the FIT
system. More information at: www.komoot.com/
1 Open the S E TT INGS ME NU.
2 Open <Connectivity><Connect Komoot>.
3 Follow the instructions on the display.
 Komoot is now connected to the system.
Connecting heart rate sensor
Different heart rate sensors can be connected
using the Bluetooth® function.
1 Open the S E TT I NGS ME NU.
2 Open <Connectivity><Heart rate sensor>.
3 Follow the instructions on the display.
 The heart rate sensor is now connected to the
system.
Adjusting the assistance system
The assistance system be adjusted to individual
requirements. The selected assistance setting
has an impact on the three levels ECO, STD and
AUTO in equal measure. The motor always
delivers full assistance when set at HIGH.
1 Open the S E TT I NGS ME NU.
2 Open <My Bike><Assistance>.
3 Use the navigation rocker switch to change
to the required assistance setting:
– If all bars are black in the indicator,
assistance has been changed to the maximum
setting. This setting means a shorter range.
– If one black bar appears on the far left-hand
side of the indicator, assistance has been
changed to the minimum setting. This setting
allows the maximum possible range at the
ECO level of assistance.
4 Press the navigation rocker switch.
 The selected assistance setting is saved.
MY24K12 - 13_1.0_01.02.2024
Calibrating the altimeter
The altimeter can be calibrated.
1 Open the S E TT INGS ME NU.
2 Open <My Bike><Calibration Altitude>.
3 Follow the instructions on the display.
 The altimeter is now calibrated. Altitude
measurement depends on the air pressure and
deviations may arise if the air pressure
fluctuates.
Adjusting the backlight
The backlight brightness can be adjusted.
1 Open the S E TT INGS ME NU.
2 Open <My Bike><Auto Backlight>.
3 – Select ON to use the backlight automatically
adjusted to the ambient light.
– Select OFF to adjust the backlight brightness
between 10 and 100%.
4 Press the navigation rocker switch.
 The selected backlight brightness will be used.
Adjusting the auto switch-off
It is possible to adjust the time interval after which
the drive system will automatically switch off when
it is not being used.
1 Open the S E TT INGS ME NU.
2 Open <My Bike><Auto Power Off>.
3 Follow the instructions on the display.
 The drive system switches off automatically
after the set time interval when it is not being
used.
Operation
141