Kettler KN170 PD Series Translation Of Original Operating Instructions page 251

Pedelecs pinion motor, fit remote basic and fit display
Table of Contents

Advertisement

10.2.5.2 UltraCore battery
In the event of a hazard, a protective circuit
switches the battery off automatically.
If a battery fault is detected, the LEDs on the
Charge Level indicator will flash.
Description
Code:
Permanent error
The battery has a permanent
error.
Code:
Charge error
The battery has been
overcharged and the charger
may have a fault.
Code:
Current and cell errors
There may be a fault in the
motor or charger, or the battery
may have gone into deep
discharge.
Code:
Temperature error
The battery is outside the
permitted temperature range.
Table 64: List of battery error messages
MY24K12 - 13_1.0_01.02.2024
Method of resolution
1
Replace the battery.
The battery is classified as
having an unknown defect in
this condition and must not be
transported by mail or air.
2
Contact specialist
dealer.
1
Contact specialist
dealer.
1
Contact specialist
dealer.
1
Allow battery to warm up
slowly in warm
environment or cool
down in a cool
environment.
2
Switch on system.
3
If flashing persists after
the battery has not been
used for a long time, it
needs replacing.
The battery is classified as
having an unknown defect in
this condition and must not be
transported by mail or air.
4
Contact specialist
dealer.
Troubleshooting, fault clearance and repair
Description
Code:
Temperature error
An authentication error may
have occurred.
Table 64: List of battery error messages
10.2.5.3 Operating element
There is a status LED on the operating element in
the navigation button.
Colour Flash sequence Status
GREE
Lights up
N
RED
Lights up
RED
Flashes
Table 65: Operating element status light
Method of resolution
1
Check the battery
connections for dirt and
clean if necessary.
2
Contact your specialist
dealer if the problem
persists.
1
Connect system to
maintenance tool at the
specialist dealer's.
1
Start system.
2
If the remote continues to
light up red, have the
component replaced at the
specialist dealer's.
1
Start system.
2
If the remote continues to
light up red, have the
component replaced at the
specialist dealer's.
251

Advertisement

Table of Contents
loading

Table of Contents