Charging The Battery; Waking The Battery - Kettler KN170 PD Series Translation Of Original Operating Instructions

6.16.3 Charging the battery

CAUTION
!
Fire caused by overheated charger
The charger heats up when charging the battery.
In case of insufficient cooling, this can result in
fire or burns to the hands.
 Never use the charger on a highly flammable
surface (e.g. paper, carpet etc.).
 Never cover the charger during the charging
process.
 Never leave a battery charging unattended.
Electric shock caused by penetration by
water
If water penetrates into the charger, there is a risk
of electric shock.
 Never charge the battery outdoors.
Electric shock in case of damage
Damaged chargers, cables and plug connectors
increase the risk of electric shock.
 Check the charger, cable and plug connector
before each use. Never use a damaged
charger.
Notice
 If an error occurs during the charging process,
a system message is displayed. Remove the
charger and battery from operation
immediately and follow the instructions.
 Contact your specialist dealer if you are
unable to recharge the battery or it is
damaged.
The battery can remain on the pedelec or can be

removed for charging.
 Remove the rubber cover from the battery.
 Connect the mains plug of the charger to a
normal domestic, grounded socket.
 Connect the charging cable to the battery's
charging port. Only use the charger supplied in
the scope of delivery.
 The charging process starts automatically.
MY24K12 - 13_1.0_01.02.2024
The indicator shows the charge level during
charging.
LED 1,2,3,4,5
Table 47: Battery level indicator on rechargeable battery
When the drive system is switched on, the display
screen shows the charging process.
Symbol Charging
0 - 5%
5 - 39%
40 - 59%
60 - 70%
70 - 90%
90 - 100%
Table 48: Battery level indicator on on-board computer
 The charging process is complete when the
LEDs on the battery level indicator go out.

6.16.4 Waking the battery

When not used for a longer period, the battery

switches to sleep mode for self-protection. The
LEDs on the battery level indicator do not light up.
 Press the On-Off button (battery).
 The battery level indicator shows the charge
level.
Operation
Battery level
100 - 80%
79 - 60%
59 - 40%
39 - 20%
19 - 10%
9 - 0%
160