Table of Contents
Advertisement
6.4.16.1 Adjusting the Suntour compression damper with continuously variable compression adjuster
Only applies to pedelecs with this equipment
1
Figure 128: SR SUNTOUR continuously variable
compression adjuster (1)
The pedelec's sag is configured.
The pedelec's rebound damping has been set.
Adjust the compression damper to the terrain
before setting off.
1 Place compression adjuster in the middle
position.
2 Setting the compression damper.
Turn the compression adjuster anti-clockwise.
The damping and compression hardness is
reduced. The deflection stroke speed is
increased.
This setting is ideal for terrain with many small,
rapid bumps. It achieves the greatest possible
wheel traction and a sensitive impact
resistance. In this setting, the rear frame
damper responds quickly and sensitively to
each impact.
This setting is unfavourable on terrain with very
uneven surfaces and large edge bumps since
there is an increased risk of the rear frame
damper bottoming out.
MY24K12 - 13_1.0_01.02.2024
Turn compression adjuster clockwise.
The damping and compression hardness is
increased. The deflection stroke speed is
reduced.
This setting is ideal for terrain with
uneven surfaces and large edge bumps.
Bottoming-out is reduced on terrain and
maximum shock absorption is achieved.
The setting is unsuitable on terrain with small,
rapid bumps. The pedelec would have poor
traction as a result. Moreover, the rear frame
damper will also not use its full deflection.
The ideal setting for the rebound damper has
been achieved when the rebound movement of
the rear wheel feels comparable to that of the
front wheel.
Operation
very
135
Advertisement
Table of Contents
