Pre Eq - Yamaha S Rev1 Owner's Manual

Sampling reverberator

Hide thumbs Also See for S Rev1:

Table of Contents

Pre EQ

The pre-convolution EQ consists of a variable frequency HPF and fully parametric

3-band EQ. Parameters can be adjusted for each channel individually on the Pre EQ

pages. In 4-channel mode, two Pre EQ pages are available: Pre EQ Front and Pre EQ

Rear. Likewise, in 2-channel x2 mode, with Pre EQ-A and Pre EQ-B pages. In addition

to numeric values, EQ settings are displayed graphically. Inactive parameters appear

shaded. Q, for example, is not active when, say, the HIGH band is set to H.SHELF.

The Pre EQ pages for each mode are shown below.

2-ch mode

4-ch mode—Front

2-ch x2 mode—A

Note that the LOW band gain and HIGH band gain parameters can also be adjusted on

the Main 1 page (see page 52). Likewise, the HPF frequency parameter can also be

adjusted on the Main 2 page (see page 54). On these pages, however, the channels are

grouped.

Use the [PARAMETER FINE] button to locate the Pre EQ page.

Use the ON/OFF button next to each EQ graph to turn on and off the Pre EQ for each

channel. Note that these buttons also turn on and off the LOW band and HIGH band

parameters on the Main 1 page.

4-ch mode—Rear

2-ch x2 mode—B

SREV1—Owner's Manual

Table of Contents

Srev1