Using An Optional Rc-Srev1 Ac Adapter; Adjusting The Rc-Srev1 Brightness & Contrast - Yamaha S Rev1 Owner's Manual

Using an Optional RC-SREV1 AC Adapter

The remote cable, which carries power from the SREV1 to the RC-SREV1, is 20 meters
in length. Since the power loss in longer cables would be too great, an optional Yamaha
PA-6 AC power supply adapter (12 V DC) is required to power the RC-SREV1 when
using remote cables over 20 meters in length. A wiring diagram for making custom
remote cables is available on page 91. See your Yamaha dealer for more information.
The optional Yamaha PA-6 AC power supply adapter should be con-
nected to the DC 12V IN connector on the rear of the RC-SREV1.
Loop the AC adapter cable around cable clip,
shown here, to prevent accidental disconnection.
Warning: Use only the Yamaha PA-6 AC power
supply adapter with the RC-SREV1. Using any
other AC adapter may cause a fault, leading to a
buildup of heat, fire, or an electrical shock hazard.
Adjusting the RC-SREV1 Brightness & Contrast
Both the brightness and contrast of the RC-SREV1 display can
be adjusted to suit your working environment or personal
preference.
Use the CONT control to set the display contrast.
1
Contrast adjusts the balance between pixels that are on and
those that are off.
Use the BRIGHT control to set the display brightness.
2
Brightness adjusts the strength of the display's backlight.

Using an Optional RC-SREV1 AC Adapter

DC 12V IN
IN
D C 1 2 V
POWER DC 12V IN REMOTE LCD
BRIGHT CONT
ON OFF
LCD
BRIGHT CONT
SREV1—Owner's Manual
27