Bypassing The Srev1; Setting The Bypass Mode - Yamaha S Rev1 Owner's Manual

40
Chapter 4—Basic Operation

Bypassing the SREV1

The SREV1 can be bypassed by using the [BYPASS] button. When the bypass function
is on, the BYPASS indicator lights up and the word "ON" appears in the BYPASS area
of the display, as shown below.
Bypass
1. Depends on the Bypass mode: Direct-out/Rev-mute. See below.

Setting the Bypass Mode

The Bypass function can be set so that it bypasses all processing (Direct-out) or just
mutes the reverb processing (Rev-mute), in which case output signals are still affected
by the Reverb Balance and Reverb Level parameters.
Input
Level
Use the [UTILITY] button to locate the Meter I/O page.
1
Use the cursor buttons to select the BYPASS MODE button.
2
Use the [ENTER] button to toggle between DIRECT-OUT and REV-MUTE.
3
The Bypass mode is set accordingly.
SREV1—Owner's Manual
BYPASS Button
BYPASS
Off
BYPASS
On
Input
Meter
Initial
Convo-
Pre EQ
Delay
lution
Display
On
Post EQ
Reverb
Off
Balance
Bypass
(Rev Mute)
Bypass status
SREV1
Normal operation
1
Bypassed
Output
Meter
On
Reverb Output
Off
Level Level
Bypass
(Direct Out)