About The Internal Operations At Startup - Yamaha S Rev1 Owner's Manual

Sampling reverberator

Hide thumbs Also See for S Rev1:

Table of Contents

About the Internal Operations at Startup

During startup, the SREV1 loads the necessary programs into the current and Quick

program memories in order to restore the SREV1 to the same state it was in before it

was last turned off. If any of these programs were previously loaded from a PC Card or

CD-ROM and then stored to a Quick memory, the same PC Card or CD-ROM will be

required to restore the contents of the Quick memories. In this case, be sure to insert

the necessary PC Card or CD-ROM before starting the SREV1. Although the SREV1's

battery-backed memory stores the titles of the current and Quick memory programs,

it does not store the actual program or impulse-response data, so this must be loaded

each time the SREV1 is started.

If a necessary PC Card or CD-ROM is not inserted, the message "DATA FILE NOT

FOUND! INSERT PCMCIA CARD" or "DATA FILE NOT FOUND! INSERT

CD-ROM DISC" appears once the RC-SREV1 has completed startup. In this case,

insert the necessary PC Card or CD-ROM and try loading again.

Note that the above information regarding necessary PC Cards and CD-ROMs also

applies to changing the Reverb mode and loading projects.

SREV1—Owner's Manual

Table of Contents

Srev1