Main 2 Parameters - Yamaha S Rev1 Owner's Manual

54
Chapter 5—Editing Programs

Main 2 Parameters

Basic parameters, including Reverb Balance, Input Level, Output Level, and Pre EQ
HPF frequency, can be adjusted on the Main 2 pages. In 2-channel x2 mode, two Main
2 pages are available: Main2-A and Main2-B. Channels are grouped, so adjusting, say,
the Reverb Balance parameter, adjusts the reverb balance of all channels simulta-
neously. In 2-channel x2 mode, A and B parameters are grouped independently. These
parameters can be adjusted for each channel individually on the Fine parameter pages.
See page 56 and page 57 for more information.
The graphs and parameter values of only one channel are displayed at a time. You can
choose which channel by using the buttons in the DISPLAY CHANNEL section of the
page. Below that section is the REV graph, which displays the reverb parameter settings
graphically, and the PRE-EQ graph, which displays the Pre EQ settings graphically. If
the EQ is turned off on the Pre EQ page (see page 57), the EQ graph appears shaded.
Likewise, if the HPF filter type parameter is set to THRU on the Pre EQ page, that also
appears shaded.
The Main 2 pages for each mode are shown below.
2-ch mode
2-ch x2 mode—A
Use the [PARAMETER MAIN] button to locate the Main 2 page.
1
Use the cursor buttons to select a channel button in the DISPLAY CHANNEL
2
section, and then press the [ENTER] button to make it the active display chan-
nel.
The button of the active display channel appears highlighted.
Use the cursor buttons to select the REV BALANCE, INPUT LEVEL, OUTPUT
3
LEVEL, or HPF parameter.
Use the faders, DATA wheel, or [–1/DEC] and [+1/INC] buttons to adjust the
4
selected parameter.
SREV1—Owner's Manual
4-ch mode
2-ch x2 mode—B