Srev1 Front Panel - Yamaha S Rev1 Owner's Manual

12
Chapter 2—Touring the SREV1 & RC-SREV1

SREV1 Front Panel

A
Air Inlet
The two internal cooling fans draw air into the SREV1 through this inlet. If the airflow
is restricted, the SREV1 may overheat, so make sure that it's not blocked.
B
INPUT and OUTPUT signal indicators
The INPUT and OUTPUT signal level indicators consist of SIGNAL and CLIP indica-
tors for each channel. The SIGNAL indicators light up when a signal is 34 dB below
clipping and are intended to show the presence of a signal, while the CLIP indicators
light up when a signal is actually clipping. See "Metering" on page 37 for more infor-
mation.
C
FS LOCK indicators
These indicators show the sampling rate—48 kHz or 44.1 kHz—and whether or not
the SREV1 is locked to the selected wordclock source. See "Selecting the Wordclock
Source" on page 75 for more information.
D
POWER switch & indicator
This switch is used to turn on the power to the SREV1. The POWER indicator lights up
when the SREV1 is turned on. See "Turning On & Off the SREV1" on page 26 for more
information.
E
MEMORY CARD slot
PC Cards can be inserted here for loading and saving programs, projects, or
impulse-response data. See "Using PC Cards" on page 29 for more information.
F
Memory card eject button
This button is used to eject PC Cards. See "Using PC Cards" on page 29 for more infor-
mation.
G
Memory card activity indicator
This indicator lights up when the inserted PC Card is being written or read. See "Using
PC Cards" on page 29 for more information.
SREV1—Owner's Manual
1
MEMORY CARD
5 67
2 3
INPUT OUTPUT FS LOCK
CLIP 48K
1 2 3 4 CH 1 2 3 4
44.1K
SIGNAL
CD-ROM
8 9 J K
4
POWER
ON OFF