Rc-Srev1 Rear Panel - Yamaha S Rev1 Owner's Manual

20
Chapter 2—Touring the SREV1 & RC-SREV1

RC-SREV1 Rear Panel

A
POWER switch
This switch is used to turn on the power to the RC-SREV1. Power is supplied by the
SREV1 via the remote cable, or an optional AC adapter. See "Turning On & Off the
RC-SREV1" on page 26 for more information.
B
DC 12V IN connector
An optional AC adapter can be connected here (necessary when a custom-made remote
cable is used). See "Using an Optional RC-SREV1 AC Adapter" on page 27 for more
information.
C
Adapter cable clip
This clip is used to secure the optional AC adapter's cable in order to prevent accidental
disconnection. See "Using an Optional RC-SREV1 AC Adapter" on page 27 for more
information.
D
REMOTE port
This 9-pin D-sub connector is used to connect the RC-SREV1 to the SREV1 with the
remote cable supplied with the RC-SREV1. See "Connecting the RC-SREV1 Remote
Controller" on page 22 for more information.
E
BRIGHT control
This control is used to adjust the brightness of the display. See "Adjusting the
RC-SREV1 Brightness & Contrast" on page 27 for more information.
F CONT control
This control is used to adjust the contrast of the display. See "Adjusting the RC-SREV1
Brightness & Contrast" on page 27 for more information.
SREV1—Owner's Manual
POWER DC 12V IN REMOTE
ON OFF
1 2 3 4
LCD
BRIGHT CONT
5 6