Yamaha S Rev1 Owner's Manual page 47

38
Chapter 4—Basic Operation
Meter I/O Page
Input and output signal levels for all channels can be metered by using the 11-segment
meters on the Meter I/O pages shown below, which are located by using the [UTILITY]
button.
2-ch mode
2-ch x2 mode
The 11-segment LCD meters have the following resolution:
CLIP, –3 dB, –6dB, –9 dB, –12dB, –15 dB, –18dB, –24 dB, –30dB, –36 dB, –42dB
SREV1 SIGNAL and CLIP indicators
Input and output signal levels for each channel can be metered by using the SIGNAL
and CLIP indicators on the SREV1 front panel. The SIGNAL indicators light up when
the signal is 34 dB below clipping and are intended to show the presence of a signal,
while the CLIP indicators light up when the signal is actually clipping.
RC-SREV1 CLIP indicators
Input and output signal levels for each channel can be metered for clipping by using the
CLIP indicators on the RC-SREV1. These indicators light up when a signal is clipping.
SREV1—Owner's Manual
INPUT
CLIP
1 2 3 4 CH
SIGNAL
INPUT CLIP
OUTPUT CLIP
4-ch mode
OUTPUT FS LOCK
1 2 3 4
CH 1 2 3 4
48K
44.1K