Multiple-unit Operating Notes
• The RC-SREV1 should be connected to SREV1 #1.
• Connect the SREV1s together by using serial cables.
• Turn on the SREV1s first, and then the RC-SREV1.
• Do not connect or disconnect any serial cables while the system is up and running.
• Do not turn off any of the SREV1s while the system is up and running.
Selecting SREV1s from the RC-SREV1
This section explains how to select the SREV1 to be controlled from the RC-SREV1.
Use the [UTILITY] button to locate the Setup page shown below.
1
Use the cursor buttons to select the SREV #1, SREV #2, SREV #3, or SREV #4
2
button in the CONNECT section of the page.
The button of the currently selected SREV1 appears highlighted. The buttons of uncon-
nected SREV1s appear shaded.
Press the [ENTER] button.
3
A confirmation message appears.
Select YES to continue, or select NO to cancel the operation.
4
Press the [ENTER] button.
5
The RC-SREV1 retrieves system information such as Reverb mode, and wordclock
source from the selected SREV1, and then updates its display. The number of the
selected SREV1 appears in the top-right corner of the display (see page 18).
Multiple-unit Operating Notes
SREV1—Owner's Manual
65