Yamaha S Rev1 Owner's Manual page 55

46
Chapter 4—Basic Operation
Note that unlike the Quick memory programs, which load instantly, programs stored
on the drives take time to load, depending on the size of the associated
impulse-response data and the speed of the drive.
In 2-channel x2 mode, when a program is loaded for reverberator A, reverberator B is
muted, unless the optional DB-SREV1 Expansion Board is installed.
Saving Programs in the Library
The current program can be saved to the following drives: Internal Card or PC Card.
Use the [PROGRAM] button to locate the Library page.
1
Use the cursor buttons to select a drive button, and then press [ENTER] to
2
make it the active drive.
The programs stored on the active drive appear in the program list.
Use the cursor buttons to select the SAVE button, and then press [ENTER].
3
The Title Edit dialog box appears.
Enter a title.
4
See "Using the Title Edit dialog Box" on page 41 for more information.
Use the cursor buttons to select the OK button, and then press [ENTER].
5
(To cancel the operation, select the CANCEL button and then press [ENTER].)
If a program with the same title already exists, a confirmation dialog box appears. Select
YES to overwrite the existing program, or select NO to cancel the operation. Note that
if the existing program is write-protected, it cannot be overwritten.
The current program, and its impulse-response data, is saved to the selected drive, and
the Edit status indicator disappears (see page 18).
Editing Program Titles in the Library
The titles of programs stored on the following drives can be edited: Internal Card or PC
Card.
Use the [PROGRAM] button to locate the Library page.
1
Use the cursor buttons to select a drive button, and then press [ENTER] to
2
make it the active drive.
The programs stored on the active drive appear in the program list.
Use the DATA wheel or the [–1/DEC] and [+1/INC] buttons to select a pro-
3
gram.
The titles of write-protected programs cannot be edited.
Use the cursor buttons to select the TITLE EDIT button, and then press
4
[ENTER].
The Title Edit dialog box appears.
Edit the title.
5
See "Using the Title Edit dialog Box" on page 41 for more information.
Use the cursor buttons to select the OK button, and then press [ENTER].
6
(To cancel the operation, select the CANCEL button and then press [ENTER].)
The new title is saved.
SREV1—Owner's Manual