First Steps; Connecting The Rc-Srev1 Remote Controller - Yamaha S Rev1 Owner's Manual

22
Chapter 3—Getting Started

First Steps

Here's how to get up and running with the SREV1.
Familiarize yourself with the SREV1 and RC-SREV1.
1
See "Touring the SREV1 & RC-SREV1" on page 11.
Install any mini YGDAI I/O cards.
2
See "I/O Options" on page 81.
Connect the RC-SREV1.
3
See "Connecting the RC-SREV1 Remote Controller" below.
Connect your audio equipment to the inputs and outputs.
4
See "Hookup Examples" on page 23.
Connect the power cord and turn on the SREV1.
5
See "Connecting the Power Cord" on page 26 and "Turning On & Off the SREV1" on
page 26.
Turn on the RC-SREV1 and Adjust the brightness and contrast.
6
See "Turning On & Off the RC-SREV1" on page 26 and "Adjusting the RC-SREV1
Brightness & Contrast" on page 27.
The SREV1 is now ready for use.

Connecting the RC-SREV1 Remote Controller

The RC-SREV1 should be connected to the SREV1 using the supplied 9-pin D-sub
remote cable, as shown below. In addition to control signals, the cable carries power for
the RC-SREV1, so make sure it's attached securely.
SREV1—Owner's Manual
2 1
AC IN
3 3
1 2 1 2
OUT DIGITAL (AES/EBU)
POWER DC 12V IN
ON OFF
SLOT
1
SLOT
2
OUT MIDI IN
2 1 2 SERIAL
2 1 2 1
3 3
IN
REMOTE
LCD
BRIGHT CONT
1 REMOTE WORD CLOCK IN
Remote cable