Table of Contents
Advertisement
Operation
Authorisation after plugging in
Display screens: charging station reserved
7.4.1
End charging
End charging with a command from the vehicle
End charging by initiating the end of charging in the controls in/on the vehicle. The DC Wallbox detects this
and gives the user a period of 3 seconds to reconnect the plug and continue charging. It then switches to the
"Available" state and lights up continuously green.
End charging by RFID or backend
Charging can be ended by holding the RFID card used to authorise charging up to the RFID card reader of the
DC Wallbox again. Charging ends immediately in this case. The DC Wallbox flashes green to indicate that a
vehicle has been detected but the DC Wallbox is "Available".
40
iONiX 25_DC-Wallbox_D00461_01_M_XXEN/01.2024
ALM: continuously blue
RFID display: continuously blue
Authorisation before plugging in
Advertisement
Table of Contents
Need help?
Do you have a question about the iONiX Light 25 Wallbox and is the answer not in the manual?