Table of Contents
Advertisement
Slave Unit：
Slave Unit is to control multiple devices
simultaneously, which are connected to same network.
("In the same network" means that the the third
section in the IP address digits are the same )
XPOSE do operation on one device, same operation
synchronized to other devices. For example, there is
another devices linked to the same network, one with
IP: 192.168.0.112, SN:0027; the other with IP:
192.168.0.129, SN: 3344.
If you want the same operation on 3344 to be backed
up to 0027, you can do as follows.
1. Set device numbers；
2. Select the IP of the device in the drop-down menu
for Device IP;
3. Click ON, the two devices are connected when the
red pot
turns to be green one
4. Click OFF to disconnect, it could not control two
devices at the same time.
3.3.3 Output|Input|Overview
Click
to check rear panel interface as shown in
the right figure.
Note: 1.
purple tip indicates input,
2. Interface Color Description: 1) Green: normal signal; 2) Yellow: abnormal signal; White: no signal.
(Due to hardware limitation, SDI output interface always displays white where there is or isn't a signal.)
Q16pro Gen2
;
blue tip indicates output,
User Manual
yellow tip indicates communication.
48
Advertisement
Table of Contents
