RGBlink Q16pro Gen2 User Manual page 32

As shown in the figure below,OSD 1 has been called on output 3, OSD 2 has been called on output
5. Therefore, lights of [IN 3] and [OUT 5] are on.
Example：If the user needs to load OSD 1 on the output port 10 and OSD 2 on the output port 12,
the following steps can be followed.
Step 1: Press [IN 10] and the light will be on to indicate OSD 1 has been loaded on output port 10.
Step 2: Press [OUT 12] and the light will be on to indicate OSD 2 has been loaded on output port
12.
3.1.4.3 Switch Mode
Press [ ENTER ] key on the panel to enter Switch Mode and the light of [ ENTER ] is ON.
Assume that in the initial state, output 1, output 3 and output 5 have been selected. Therefore,
lights of [OUT 1], [OUT 3] and [OUT 5] are on if [ ENTER] key is pressed, as shown in figure below.
Q16pro Gen2 User Manual
31