Table of Contents
Advertisement
Step 4: Press [IN 5] to switch input signal 5, instead of input signal 1 set before, to the
synchronous output group. Light of [IN 5] will be ON.
3.1.4.4 Scene Mode
Press [ LOAD ] key on the panel to enter Scene Mode and the light of [ LOAD ] is ON.
Press [OUT 1-16 ] to load saved presets. (Notice: only ONE scene can be selected at the same
time)
LOAD Light on if Scene Switch Mode is triggered. Push LOAD button again to return to Matrix
Mode.
Example 1：The initial status is that no scene has been used before . If you want to enter to scene
1, the following steps can be followed.
Step 1: Press [LOAD ] to enter non-saved scene mode, and the light will be on.
Step 2: Press [OUT 1] to load Scene 1.
Q16pro Gen2
User Manual
33
Advertisement
Table of Contents
